Wiring diagram - Warn winch remote plug
4,921 views
Skip to first unread message
Dave Morgan
May 19, 2008, 11:03:56 AM5/19/08
to LROC Techtorque Discussion Forum
I broke the lead of my winch remote at the Action
Trial. I am hoping to have it fixed but in the meantime does any one have a
wiring diagram for the plug in the control box. You can get the winch to work by
bridging the right pins but which are which?
Thanks,
DaveM
Bertus Bekker
May 19, 2008, 12:56:46 PM5/19/08
to lroc-te...@googlegroups.com
What make of winch, Dave?
Derrick Slogrove
May 19, 2008, 1:30:14 PM5/19/08
to lroc-te...@googlegroups.com
Bertus,
Reading the subject line of Dave’s email may give you a clue J
Derrick
Liquid Automation Systems, LAS Cool Sorption and LAS Garage Equipment disclaim all liability for any loss, damage or expense however caused,
arising from the sending, receipt or use of this e-mail communication and on any reliance placed upon the information provided through this
service and does not guarantee the completeness or accuracy of the information.
This message may contain information which is confidential and subject to legal privilege. If you are not the intended recipient, you may not peruse,
use, disseminate, distribute or copy this message. If you have received this message in error, please notify the sender immediately by e-mail,
facsimile or telephone and return and / or destroy the original message.
Bertus Bekker
May 19, 2008, 1:59:10 PM5/19/08
to lroc-te...@googlegroups.com
Thanks Derrick - I should learn to read the 'fine' print.
Can not help then, Dave - could have checked a Ramsey control for you.
But the basics should the same - one pin power, one pin forward and one reverse - bridging forward and reverse will do nothing, bridging power to any of the other two will operate the winch in either direction.
Regards
alla...@mweb.co.za
May 19, 2008, 2:09:20 PM5/19/08
to lroc-te...@googlegroups.com
Hi Dave
The common problem is yanking the cable and the connectors come off the back of the switch. It is possible, although difficult to pull the switch surround through the rubber handle and check the wires. If my memory is correct the black has the power and it switches to red or green. I did this and have had no problems since.
The other solution is to take the top plate off the winch, 4 allen key bolts and pull a three strand wire through the power cable opening and run it to a switch on the dash, put a switch in line under the bonnet to prevent accidental activation
Hope it helps
Allan
0 new messages